• Digital Paint Discussion Board »
  • Development »
  • Mapping (Moderator: Chef-Killer) »
  • sliding doors
« previous next »
Pages: [1]

Author Topic: sliding doors  (Read 1048 times)

Fullmetal_Steeb

  • 68 Carbine
  • Posts: 353
sliding doors
« on: September 27, 2007, 06:05:21 PM »
How do you pick which way a door entity will open when someone walks by it? I can only get it to open the way the person is supposed to walk, instead of going off to the side...
Logged

DrRickDaglessMD

  • 68 Carbine
  • Posts: 376
Re: sliding doors
« Reply #1 on: September 27, 2007, 06:28:53 PM »
set the key 'angle' and a value between 0 and 360 in the door entity. A little arrow showing the direction should appear after you add the key.

Hope this helps.

- Dagless
Logged

Fullmetal_Steeb

  • 68 Carbine
  • Posts: 353
Re: sliding doors
« Reply #2 on: September 27, 2007, 07:08:42 PM »
Definitly. Thanks, DRDMD. :)
Logged

Zorchenhimer

  • Autococker
  • Posts: 2614
Re: sliding doors
« Reply #3 on: September 27, 2007, 07:23:10 PM »
And I think "angles" is what you use when you want it to go up/down/45 degree angle. You would specify 3 angles (X,Y,Z) instead of just one.

Someone please correct me if I am wrong.
Logged

Fullmetal_Steeb

  • 68 Carbine
  • Posts: 353
Re: sliding doors
« Reply #4 on: September 27, 2007, 07:52:15 PM »
No, your right. I checked it. Pitch, roll, and yaw (aka X Y and Z)
Logged
Pages: [1]
« previous next »
  • Digital Paint Discussion Board »
  • Development »
  • Mapping (Moderator: Chef-Killer) »
  • sliding doors