• Digital Paint Discussion Board »
  • Development »
  • Mapping (Moderator: Chef-Killer) »
  • Phong not working
« previous next »
Pages: [1]

Author Topic: Phong not working  (Read 983 times)

CarbineXT

  • Stingray
  • Posts: 64
Phong not working
« on: August 14, 2006, 12:02:21 PM »
Hello again all,

I tried to use phong shading with BSP, I created a super simple terrain in GenSurf and applied the same Value to all of it, but nothing happened. Do I need to upgrade ArghRad or something?

Thanks.
Logged

jitspoe

  • Administrator
  • Autococker
  • Posts: 18802
Re: Phong not working
« Reply #1 on: August 14, 2006, 12:21:09 PM »
It wouldn't hurt to upgrade arghrad, but the version included with the bsp pack supports phong shading.  Are you sure you hit "apply to brush" after selecting all the brushes and setting the value?
Logged

Eiii

  • Autococker
  • Posts: 4595
Re: Phong not working
« Reply #2 on: August 14, 2006, 01:11:13 PM »
I would also hope that you're lighting the map instead of just BSPing it.
Logged

CarbineXT

  • Stingray
  • Posts: 64
Re: Phong not working
« Reply #3 on: August 14, 2006, 04:10:05 PM »
I did click Apply to Brush after setting the BSP value, and I compiled it with a skybox, qbsp vis rad. The shadows and all that were there so I beleive it is lighted. However there was definitely no phone.
Logged
Pages: [1]
« previous next »
  • Digital Paint Discussion Board »
  • Development »
  • Mapping (Moderator: Chef-Killer) »
  • Phong not working